
Monitoring Dell R710 Running VMware vSphere ESXSection 8 Monitoring VMware vSphere ESX(i)
64 3BSE056141-510 F
Monitoring Dell R710 Running VMware vSphere ESX
The following describes the procedure to setup System 800xA to monitor a Dell
R710 which is running VMware vSphere 4.1. It is assumed that VMware vSphere
ESX 4.1 is installed on the Dell R710 server. A brief list of the pre-requisites is
presented followed by the stepwise procedure for configuring the VMware vSphere
ESX server and the System 800xA. Once the monitoring is configured, it is essential
that it is tested in a non-destructive manner.
Pre-requisites
Hardware:
•Dell R710.
Software:
• VMware vSphere ESX 4.1.
• Dell OpenManage Server Administrator Managed Node.
• OM-SrvAdmin-Dell-Web-LX-6.4.0-1266.ESX41.i386_A00.2.tar.gz.
• System 800xA SV5.0 SP2 or higher with Asset Optimization server.
• 2PAA102558_J_en_DeviceObjectType_Base_V1_9_PNSM.
• 2PAA105767_B_en_DeviceObjectType_Dell_Poweredge_R710_V1_1_PNSM.
Procedure Summary
To setup System 800xA to monitor a Dell R710 which is running VMware vSphere
4.1 perform the following steps:
1. Configure networking of ESX and 800xA AO Server.
2. Install & Configure HP System Management in the ESX server.
3. Install & Configure 800xA PNSM Object types for R710.
Configure Networking of ESX and 800xA AO Server
Review the Setup Network Connections of this manual.
Komentáře k této Příručce