
OneCommand™ Manager Application P007997-01A Rev. B
8. Managing Adapters and Ports
FC/FCoE
121
PFC Properties Area
State – Enabled means that flow control in both directions (Tx and Rx) is
enabled.
Active Priority – Lists the priorities with PFC set to Enabled.
Sync’d – If yes, the PFC priorities have been set by the peer. This parameter
cannot be set.
Error – The error state. This capability indicates whether an error has occurred
during the configuration exchange with the peer. Error is also set to YES when
the Compatible method for the capability fails.
FCoE Properties Area (FCoE ports only)
State – The FCoE state. It can be Enabled or Disabled.
Active Priorities – The current active priority assigned for FCoE.
Sync’d – If yes, the FCoE priority has been set by the peer. This parameter
cannot be set.
Error – The FCoE error state. This capability indicates whether an error has
occurred during the configuration exchange with the peer. Error is also set to
YES when the Compatible method for the capability fails.
ETS Priority Group Properties Area
State – The FCoE or NIC-only state. It can be Enabled or Disabled.
Sync’d – If yes, the Priority Groups have been set by the peer. This parameter
cannot be set.
Error – The error state. This capability indicates whether an error has occurred
during the configuration exchange with the peer. Error is also set to YES when
the Compatible method for the capability fails.
Active Groups
PG – The Priority Group number. It can be 0 to 7.
Priorities – The priorities that are assigned to each Priority Group. It is
represented in comma separated format.
Bandwidth % – The percentage of available link bandwidth allocated to a
particular Priority Group.
Max Configurable PGs – This field indicates maximum number of priority
groups that can be configured on the selected OneConnect adapter port.
DCB Tab Buttons
Configure DCB – Click to configure DCB parameters. See the instructions
below.
To configure DCB for FCoE adapter ports:
1. From the discovery-tree, select the adapter port whose DCB properties you want to
configure.
2. Select the DCB tab.
Komentáře k této Příručce