VMware VCENTER APPLICATION DISCOVERY MANAGER 6.1 - REPOSITORY Uživatelský manuál Strana 122

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 220
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 121
OneCommand™ Manager Application P007997-01A Rev. B
8. Managing Adapters and Ports
FC/FCoE
122
3. Click Configure DCB. The Configure DCB dialog box appears.
4. Configure the settings you want and click OK.
Note: An error message is displayed if you try to configure more priority groups
than the adapter supports. The “Max Configurable PGs” field shows the
number of priority groups supported by the adapter.
Figure 8-32 Configure DCB Dialog Box for FCoE Adapter Ports (DCBX Enabled)
Configure DCB Dialog Box Field Definitions
DCBX Settings Area
Enabled – DCBX can be enabled or disabled. With DCBX enabled, the
configured values are used only if the switch does not provide them. With
DCBX disabled, the configured values are used.
DCBX Mode – The DCBX mode can be set to CEE or Cisco-Intel-Nuova (CIN).
Changes to the DCBX mode require a reboot of the host.
Operating Version – Operating version of the DCBX protocol. The system
adjusts as needed to operate at the highest version supported by both link
partners. This setting cannot be changed.
Maximum Version – The highest DCBX protocol version supported by the
system. Version numbers start at zero. The DCBX protocol must be backward
compatible with all previous versions. This setting cannot be changed.
Zobrazit stránku 121
1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 219 220

Komentáře k této Příručce

Žádné komentáře