VMware VCENTER APPLICATION DISCOVERY MANAGER 6.1 - REPOSITORY Uživatelský manuál stáhnout pdf (Strana 47)

OneCommand™ Manager Application P007997-01A Rev. B

5. Configuring Discovery

Discovery Using the TCP/IP Access Protocol

Figure 5-4 Add Range of TCP/IP Hosts Dialog Box

To add a range of remote hosts:

1. From the Discovery menu, select TCP/IP>Add Range of Hosts. The Add Range of

TCP/IP Hosts dialog box appears.

2. Enter the complete start and end address range (IPv4 only) and click Add. The

added address range appears in the dialog box. Add any additional ranges you

want to search.

3. Click Start Discovery. If an address is remotely manageable, it is added to the list of

addresses that the discovery server will attempt to discover. The utility creates a

host file if necessary, and checks each address in the range to determine if the host

is available and remotely manageable. The number of addresses (of manageable

hosts) discovered is periodically updated on the dialog box.

Note: The number of addresses does not correspond directly to the number of

hosts added to the discovery-tree. For example, some of the addresses

discovered may be for hosts that have already been discovered over FC.

However, new adapters can be discovered on those hosts that were not

discovered over FC.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 219 220

Žádné komentáře

VMware VCENTER APPLICATION DISCOVERY MANAGER 6.1 - REPOSITORY Uživatelský manuál Strana 47